bicyclenut
Member
Added power plug under seat this morning, quick and easy modification of about 15-20 minutes. I had previously freed up the ready to install plug from the harness when I had the side Tupperware off for my Admore light installation so it was in place and ready. Just had to drill a 5/8 hole in plastic near tail lamp access door and I was able to carefully work with socket and wire through the access opening. Part was available from BMW, a bit pricey at $38 but easy to do with no splicing.
Just need to clean up the plastic mess from the drilling and figure out what I will use it for.
Sent from my iPhone using Tapatalk
Just need to clean up the plastic mess from the drilling and figure out what I will use it for.
Sent from my iPhone using Tapatalk