Floor board removal

P

performanceguy

New member

• Sep 5, 2023

• #1

Any tips/procedure for floor board (black grippy) removal. Seems like it pulls up but I don't want to break any tabs.

It is in relation to the installation of this item : https://www.tucanourbano.com/en/pp/termoscud-blue-r233pro-111262

Thanks.

 

triangletom

Active member

• Jan 30, 2024

• #2

I couldn't figure it out either, so I skipped this installation step with the Termoscut. I'd like to figure it out though for proper fitment.

 

P

performanceguy

New member

• Jan 30, 2024

• #3

I'll check again and see if I can find the tabs.

 

triangletom

Active member

• Jan 31, 2024

• #4

For those of you curious what we're talking about, it's step 6 from https://cdn.0brandcommerce.com/tucanourbano/pdf/R233PRO.pdf


I, too, tried yanking the rubber floor board upwards - while it gave a little, it also had enough resistance that I didn't want to force it. I see now from the diagram that I started much lower down than it indicates. I'd call this installation step "optional", but it'd be nice to secure the skirt down there.

 

triangletom

Active member

• Jan 31, 2024

• #5

You know what, I yanked a little harder at the right spot and it revealed the screw hole mentioned in the picture without a big fuss. I'll have to try setting the skirt up properly now.

 

triangletom

Active member

• Feb 16, 2024

• #6

Here's a picture showing where the screw is. I just tugged on this part of the floorboard with my fingers.

 

triangletom

Active member

• Feb 16, 2024

• #7

You can see the two tabs - fore and one aft, they seem quite sturdy and difficult to break. They went back into place with no issue after pounding on the floorboard with my palm.