Search results

I'd been curious about those guys. Out of Poland, right? Let us know how you get on with the Puig.

Again, I must plead guilty. Had that one on my 2014 Sport. It performed worst of the lot, honestly. High speeds pushed the top edge downward 6-10 cm (depending on headwind direction), it too developed cracks, and when it came time to remove it and replace it with a Givi, I had to hacksaw off...

On my Sports, I've run the stock screen, then a tall Givi, and finally the Puig. Prefer the Puig out of the lot. Head buffeting I experienced with the stock shield made me shop for aftermarket choices. Got the Givi. Givi is a thicker screen, but mine developed small cracks at 2 of the mounting...

Nice ride, Del! Glad your search is over (for now). :)

Since the variator bell and output shaft both show wear (metal missing/out of true on the positive-negative teeth of their mating surface), both will require replacement. But the variator was otherwise in good condition before this suddenly cropped up. If the variator could be replaced without...

Hi all, This summer, my c650 Sport started eating drive belts. After the second belt incident, I had the bike towed to my mechanics, and they took apart the CVT assembly, only to find that the output shaft from the engine case to the CVT was very worn, with pitting and jagged edges on the...

I run this Yuasa in my GT and Sports. Affordable, and a slightly higher CCA than the OEM cell for peace of mind. Usually get them from Chaparral (either direct or via eBay for under $100 shipped.

What @zx10guy said -- I just ordered about a grand of shiny bits for my new-to-me GT from this site, and they got it Stateside quick and without hassle. But I'd also suggest that you toss the part numbers you need (no spaces) into an eBay search that looks like this BMW (12345678, 23456789...

Edit: They do make one for the Sport. Part # is 77 31 8 527 011. Looks like a $300 price tag. @zx10guy -- Here's a listing on eBay for a more manageable price for the Tucano Urbano Cessie linked -- if you wishlist the item, the seller might send you a special offer for a little less off the ask...

The 2016 GT I picked up is my first, my other 2 are Sports (1 running, the other with a wounded output shaft I'm trying to figure out how to rebuild without exceeding replacement cost). I have to admit that part of the reason I wanted a GT was a chance to play with all the accessories. For...

I hit 110 mph on my 2014 Sport more than a few times, and wasn't even at wide-open throttle, and was still capable of breaking 100 mph after I'd swapped to 28g Dr. Pulley rollers (I just don't specifically remember it going to 110, so I can't vouch for it. Yours should be similarly capable...

Bummer on the 2013, but if logistics weren't a factor, I'd have too many bikes. :) I just figured if you were on the hunt for a c650 again, you might've seen the black 2016 I snagged in Georgia for $3,000. It has a couple minor issues (gas spring that holds the seat up when opened needs...

Doubling down on what zx10guy said. By model year 2017 all c650s have a hydraulic tensioner. It's the first half of 2016 production that don't have them, but I've yet to pinpoint when the change got fully implemented on the assembly line, as all of my 2016s came with the less-good tensioner...

In my explorations I didn't see any aftermarket springs or mounts to change the OE shock behavior, so while it might be possible, I bet you'd have to have something fabricated -- at which point, why not buy the Malossi? As for my bike, I just got a call with bad news, which I'll write up in...

Hi. I don't have direct experience, but unlike California, over here on the East Coast we go through Winter -- and that's when I spend my time indoors and go shopping for stuff like this. :) Here are the options I found. Gears H2 EMC Shocks Nitron (mentioned in the thread over in the...

Sorry for the late reply, Doc, haven't been on this board in a bit. To answer your questions: I'm using THESE. Did a pre-sales call with the team there, they promised they'd work, and they do. Beam pattern's largely identical to a stock bulb, because the emitter is (supposedly) positioned in...

It's an H7 bulb -- any bulb of that size can fit (doesn't have to be a "motorcycle" bulb). I've used cheap ones, more expensive ones, and now have LEDs installed. Generally, the brighter bulbs run, the shorter the lifespan on the road.

Nope!

Hi Mike, I haven't seen any refurb kits for C-Series scooters -- for any sub-system of the bike. Dealers (both BMW and independent) tend to just order parts one-by-one I'm afraid. So you'll have to page through the BMW parts fiche for the stuff you want (HERE is a dealer close to me that I...

On my 2016 Sport, I was told to replace the seals/bearing at my 6k service, and did so. At my 18k service (at a different dealership), the tech noted the same issue, and suggested seal replacement, but the owner of the dealership recommended I not bother repairing the seals, since this was a...