mikeperson
New member
Hi Everyone, Hoping I can get some help from the C600 community!
my Turn signal button broke off, have been using the nub for a while now, I would like to 3d print a replacement but I dont have the old button to measure for dimensions.
Could one of you fine folks take a pair of calipers and measure the three points I think I would need to recreate this button digitally? I would gladly share it with the community when I'm done!
A: Width of the button
B Width of the tip
C Height of the tip ( and I assume height of the button overral)
Also, could you take a picture from above the button as squarely as possible to capture the curve of the left and right sides as seen from the top? So you take a one dimensional picture of the button, the "OFF" text will be visible.
my Turn signal button broke off, have been using the nub for a while now, I would like to 3d print a replacement but I dont have the old button to measure for dimensions.
Could one of you fine folks take a pair of calipers and measure the three points I think I would need to recreate this button digitally? I would gladly share it with the community when I'm done!
A: Width of the button
B Width of the tip
C Height of the tip ( and I assume height of the button overral)
Also, could you take a picture from above the button as squarely as possible to capture the curve of the left and right sides as seen from the top? So you take a one dimensional picture of the button, the "OFF" text will be visible.
Attachments
Last edited: